MicroLinks UM12 - user manual - Manual (Page 19)

Microscope Software manual http://www.ViTiny.com
19
Copyright © 2008-2014 MicroLinks Technology Corp.
 Open file：To choose the location of pictures.
 Save file：To choose the saving location after pictures convert to video.
 File source：The opened video file location.
 File saved at” To choose the file saved location.
 File name:
 Auto-generated: Auto generated folder name by yyyy-mm-dd-hh-min-sec.
 Manual Keyin：Key in folder name
 Compressed Status：To decide whether to use compressor. It’s suggested to
use DivX to compress high quality of file.
 File name: To show the generated file name after converted into video.
 Total files：Total file numbers.
 Unselected files: Numbers of unselected files.
 Selected files: Numbers of selected files.
 Select: Select files. Multiple selection is available.
 Select all：Select all files.
 Deselect：Deselect the selected file, multiple selection is available.
 Deselect all: Deselected all files.
 Reset: Return to original select status.
 Execute: Enable image convert video function.
Cancel: Close the image convert video function dialogue.
2.4.6 Processing information
To show the Time Lapse, Image convert video or video convert image processing status.
(1) Time Lapse
The tabs is to show all Processing information about Time Lapse, see Fig 2-23:
 Function status: To know the function is enabled or disabled.
 Save file format as: To know the capture file type.
 Start time: Count down until “0” to enable this function.
 Record time: To show the capture time from begin til now.
 File number: The current capture file numbers.
 Total time: Count down until “o”, to disable this function.
 Time interval: Count down until “1”, capture next file.
 Open saved file: To open the captured files saving location.
 Enable: Enable or Disable the function.
 Close: Close the processing information dialogue.