MicroLinks UM12 - user manual - Manual (Page 58)

Microscope Software manual http://www.ViTiny.com
58
Copyright © 2008-2014 MicroLinks Technology Corp.
 Set ruler position & show (0,0) position
Ruler can display at Horizontal or Vertical position as per example per below
Fig.5-52 options. The image results in Fig.5-53.
Fig.5-52 Ruler vertical and horizontal
position setting
Fig.5-53 Ruler vertical and horizontal Display
 To set up the horizontal effective range
As shown in Fig. 5-54, there’re two options for horizontal effective range setup.
The default setting is auto-detection which is able to define the effective display.
If the detected value is “0”, or adjustment required, the manual adjustment
function is also available. There are different unit options, cm and inch,
available in manual adjustment mode.
Figure 5-54 Setting effective horizontal dimension on monitor
When the “magnification display” is checked, as shown in Fig. 5-54, the
magnification ration will show on the upper right corner of the display window
based on display size, image resolution and preview window size. The ratio is
calculated by Field of View. Field of View is the calibrated horizontal and
vertical scale. Users could also calculate the ratio by rulers, please refer to Fig.
5-56. The displayed 1.00 mm equals to 16.2mm ruler scale, therefore, this is