MicroLinks UM12 - user manual - Manual (Page 51)

Microscope Software manual http://www.ViTiny.com
51
Copyright © 2008-2014 MicroLinks Technology Corp.
c. Cross (High Magnfication)
The main purpose for the Cross is to calibrate the default setting in software and
also to measure. The Cross (See above chart c) has 3 kinds of units as 0.05mm, 0.1mm
and 1mm scale. It will measure 0.05mm, 0.1mm at high magnification and 0.1mm,
1mm at low magnification. The Cross can measure the Length and Width accurately,
ie.: Fig.5-34, Measure the length of the onion cell as the red rectangle which is
approximate 0.400mm.
Fig 5-31c way to use Cross
d. 0.1mm High Magnification Grid
High Magnification grid is used for observing tiny object. See Fig.5-31d, put the
0.1mm scale (See above chart d) on “ ” microdot. The Length of in a square i.e.
0.100mm.
Fig 5-31d way to use High magnification Grid
e. L Type Low magnification ruler
L Type low magnification is used for calibrating or measuring low magnification.
The unit is CM, the section is 1mm.
Choose the suitable calibrator based on different observation needs, due to the
calibrator is transparent, it can place on the object then observing by microscope.