Water pipe or hose connection, Installation (cont.) – MovinCool Office Pro W20 User Manual
Page 10
10
INSTALLATION (cont.)
Water Pipe or Hose Connection
WARNING: Before plugging in the unit, connect the water line to the
unit. To avoid electrical shock, make sure that there is no water
splashed onto the electrical box or the power cord.
Office Pro W20 unit has two female 1/2 inch NPT (National Pipe Thread) water
connections.
Optional water hose kit with water pressure up to 150 psi (1,034 kPa) is available.
Connecting Water Pipes
Two water pipes with the 1/2 inch NPT male end connections are required for field
installation.
1. Remove the caps from the female NPT connections on the right side panel of
the unit.
Note: Small residues of water may drip when the caps are first removed.
2. Apply teflon tape to the male threads on the two pipes.
3. Connect the two water pipes with the male end connections to the female
connections on the unit. Hold the wrench A tightly so that the pipe on the unit
is not deformed, then tighten the connector with the wrench B.
Note: The supplied garden hose adapters are not required.
CAUTION: Use two proper size wrenches.
ITEM
CONNECTION TYPE
CONNECTOR
HEAD SIZE
FEMALE
MALE
Office Pro W20 unit
1/2 in NPT
-
1 in
Supplied Garden Hose Adapter
GHT
1/2 in NPT
1-3/16 in, 7/8 in
Optional Water Hose
GHT
GHT
1-3/16 in, 1-3/32 in
WRENCH A
WRENCH B
ILL00087-00