MovinCool Office Pro W20 - Manual (Page 16)

16
INSTALLATION (cont.)
LCDI Power Cord Instruction
WARNING: The LCDI device is a non-serviceable device.
Attempting to open the device may expose the user to the hazards
of electric shock, and could void warranties of this product.
Manufacturer's reliability is limited to the replacement of the device.
CAUTION:
1. Read the attention printed on the device for proper use and
handling of this device.
2. This device is used for monitoring leakage current.
3. Do not immerse in water.
4. This device must only be plugged into an appropriate wall outlet.
Do not use on extension cords or adapter. Do not remove ground prong.
5. In the event that this device trips, the cause of malfunction should
be corrected first before further use.
6. Using the device beyond recommended voltage poses risk to users.
7. Conductors inside this cord are surrounded by shields, which
monitor leakage current. These shields are not grounded, and they
are periodically examined the cord for any damage. Do not use this
product in the event the shields become exposed.
8. Do not repeatedly push the TEST and/or RESET buttons.
Test Procedure
Test device once when AC is installed to assure proper operation.
1. Plug into grounded power receptacle.
2. If light is not on, press RESET button once. Light should turn on.
3. Press TEST button once, light must turn off.
4. Press RESET button once again for use. Light should turn on.
5. If test fails, do not use. Contact a qualified technician for details.
<FRONT VIEW>
TEST Button
RESET Button
ILL00049-00