MovinCool Office Pro W20 - Manual (Page 20)

20
OPERATION (cont.)
Operating Modes
The Office Pro W20 can be operated in two modes, FAN ONLY and COOL. When
in FAN ONLY mode, the unit circulates the surrounding air. When in COOL mode,
the compressor is operated and cool air is circulated.
1. COOL Mode
Once the compressor has been disengaged for more than 120 seconds, the
unit operates in FAN ONLY mode for approximately 5 seconds before the
compressor re-engages.
2. Temperature Control
The room temperature thermistor monitors the inlet temperature versus set
point temperature and switches the unit automatically between COOL and
FAN ONLY modes.
3. Fan Mode Control DIP Switch
The fan mode control DIP switch determines whether the fan continues to
operate or stop when the compressor cycles off. (Set point temperature below
the inlet air or room temperature.) The unit has been preset at the factory for
continuous fan operation.
Note: If you want to change the fan mode operation (from OPERATE to
STOP), contact your MovinCool reseller.
4. Temperature Scale Display DIP Switch
The temperature scale display DIP switch changes the temperature(s) that are
displayed to either °C or °F. The unit has been preset at the factory to display
the temperature(s) in °F.
Note: If you want to change the temperature scale display (°F to °C), contact
your MovinCool reseller.