MovinCool Office Pro W20 - Manual (Page 30)

30
INSPECTION & MAINTENANCE (cont.)
Water Regulating Valve (cont.)
Adjustment of Water Regulating Valve Setting
1. Stop the unit and unplug the power cord. Then shut off the water supply.
2. Remove five (5) screws from the service panel on the rear side of the unit.
3. Remove thirteen (13) screws from the rear panel.
4. Check the valve setting guide table on the inside panel of the unit to confirm
the current valve setting. If the table is blank, it is the first time adjustment. If
the table shows the previous value setting, the current setting must be
changed back to the original default setting prior to making any adjustment.
5. Make sure the adjusting plate is aligned with the default marking line on the
housing. If it is not aligned, rotate the adjusting bolt with a wrench until it is
aligned. At this position the water regulating valve is returned to the original
default setting.
ILL00156-00
SCREWS (5)
ILL00168-00
SCREWS (7)
SCREWS (3)
SCREWS (3)