Plugging in the unit, Installation (cont.) – MovinCool Office Pro W20 User Manual
Page 13
13
INSTALLATION (cont.)
Plugging in the Unit
1. Check the prongs and surface of the power cord plug for dust/dirt. If dust and/
or dirt are present, wipe off with a clean, dry cloth.
2. Check the power cord, plug and prongs for damage or excess play. If any
damage or excess play is found, contact your MovinCool reseller or a qualified
technician for repair.
WARNING:
1. If the power cord or plug is damaged, replacement should only be
performed by qualified electrical personnel.
2. Do not connect/disconnect the power cord or attempt to operate
buttons with wet hands. This could result in electrical shock.
3. Because of potential safety hazards under a certain condition, we
strongly recommend against the use of an extension cord.
However, if you still elect to use an extension cord, it is absolutely
necessary that it is a UL listed, 3-wire grounding type appliance
extension cord, having a 3-blade and a 3-slot receptacle that plugs
into the appliance. The marked rating of the extension cord should
be 115 V, 15 A or equivalent.
CAUTION: The power supply should be a dedicated single outlet
circuit with UL recognized short-circuit and ground-fault protective
breaker. Do not share the AC outlet with any other instrument or
equipment. The minimum power supply rating and the maximum
fuse size is shown below.
Note:
1. Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign
matter.
2. The Office Pro W20 is equipped with UL recognized LCDI cord and NEMA plug
configuration (5-15). The appropriate outlet must be used for this plug type.
MINIMUM POWER SUPPLY RATING
RECOMMENDED FUSE SIZE
115 V, single phase, 60 Hz, 15 A
15 A maximum