OpenEye GraniteRack 3U - Manual (Page 39)

Configuring
3-1
!
Chapter 3
Configuring
The subsystem has a setup configuration utility built in containing important
information about the configuration as well as settings for various optional
functions in the subsystem. This chapter explains how to use and make
changes to the setup utility.
Configuration Methods
There are three methods of configuring the subsystem. You may configure
through the following methods:
• VT100 terminal connected through the controller’s serial port
• Front panel touch-control keypad
• Web browser-based Remote RAID management via the R-Link ethernet
port
Important:
The subsystem allows you to access the utility using only one method
at a time. You cannot use both methods at the same time.
3.1 Configuring through a Terminal
Configuring through a terminal will allow you to use the same configuration
options and functions that are available from the LCD panel. To start-up:
1. Connect a VT100 compatible terminal or a PC operating in an equiva-