RJS Inspector D4000 Laser (FIRMWARE version A.05 and Earlier) - Manual (Page 50)

Appendix F Operator ’ s Guide
RJS, Minneapolis, MN 002-5568 44
Appendix F (Symbology Analysis)
Symbology Analysis Parameters
Table F-1 shows error messages that will be displayed for each parameter type checked by
the Laser Inspector.
Table F-1 (Parameter/Error Message)
Parameter Data Analysis Message
Ratio Warning Ratio
Inter-Character Gap (ICG) Invalid Format
Data Character Invalid format
Mod Check Digits Bad Mod Check
Bar Width Deviation Range Warning Wide (or narrow)
Bar Width Deviation Ave. Rejected Wide (or narrow)
Addendum Parity
(UPC/EAN) Invalid Format
ANSI Decodability
(if enabled) Warn D/bility (DCD, in initial
Pass/Fail screen)
Object in Quiet Zone Warning QZ/SS