SONOSAX MINIR82 - Manual (Page 17)

SONOSAX MINIR82 - User interface V4.2 Page 17 de 32
4.5.2 ROUTING SETTING
SETUP > ROUTING SETTINGS > ROUTING TABLE
The routing, or channel assignement to the tracks, is done by means of a specific matrix as shown below:
ROUTING MATRIX
The round dot assigns the inputs channels to the tracks. Any combination is possible, thus any input channel
can be routed to any track or to multiple tacks and multiple channels can be routed on the same track
(mixing).
The figure above shows a 1x1 routing between inputs and tracks 1 to 4. Inputs 5 and 6 are routed to tracks
7 and 8. In addition, input channels are also individually routed to the tracks of the CF card.
Keys Short pressure Long pressure
LEFT Move the selection cursor to the Left Return to the previous menu
RIGHT Move the selection cursor to the Right Activate/Deactivate the assignment
UP Move the selection cursor upward
DOWN Move the selection cursor downward
NOTES: The configuration is automatically saved when leaving this menu
The un-assigned Tracks (no dot on the crossing) are automatically desactivated.
SETUP > ROUTING SETTINGS > MIXING LEVEL
The [MIXING LEVEL] menu defines the attenuation to be applied to each channel when summing (mixing)
multiple input channels onto the same track; the attenuation is computed to avoid a digital clipping. Four
possibilities are offered and the choice depends on the phase coincidence of the sources.
• NONE
no attenuation at all
• ATT1.5
mainly used if the sources have no phase coincidence
• ATT3
recommanded for phase coincident sources such as sereo or M/S microphone
• ATT6
only used if the sources are absolutaly in phase
The table below summarizes the exact attenuations computed and applied according to the number of input
channels assigned to the same track.
Number of input channels
assigned to the same track
NONE
[ in dB ]
ATT1.5
[ in dB ]
ATT3
[in dB ]
ATT6
[ in dB ]
1 0 0 0 0
2 0 1.8 3.3 6
3 0 2.5 5 10.1
4 0 3.3 6 12
5 0 3.3 7.2 14.5
6 0 4.1 7.2 14.5
7 0 4.1 8.5 18.1
8 0 5 8.5 18.1
H.D. Tracks
Input Channel
Routed cross point = active track
Selection cursor
CF Tracks
Assign / Un-assign the tracks Save and return to the
No cross point = inactive track