Allmand Brothers NL PRO II - Manual (Page 18)

18
TRAILERING, TRANSPORTING AND LIFTING
Shutdown - Prepare for Trailering
1. With the tower lights off, lower the light tower to the full DOWN position; See Raising and Lower-
ing the light tower on page 44-45.
2. Turn the engine off. Refer to your Engine Operator’s Manual for stopping procedure.
Notice: See appropriate section of the Engine Operators Manual and Generator Operator’s
Manual for additional post - operation and shutdown procedures.
3. Adjust the light bar and light fixtures for trailering; see Tower lights - Stowage for trailering on
Page 19.
Notice: Visually inspect the light mounting brackets and hardware for loose fasteners or
damaged brackets. Repair any problems before trailering.
4. Secure the light cords into the hook on the rear mast support . (Laydown Tower only).
5. Disconnect the ground rod cable from the ground lug. Remove the ground rod from the earth and
clean and secure the ground rod and cable in the trailer.
6. Close, secure and lock all compartment doors.
7. Raise each rear stabilizer jack and rotate into trailering position ( horizontal with outrigger bar).
8. Retract each outrigger bar and secure in the stowed position with latch pin.
Notice: Be sure each outrigger jack is securely latched in transporting position by installing the
outrigger lock pins before transporting.