Allmand Brothers NL PRO II - Manual (Page 43)

43
OPERATION
Lights - Trailering storage
The light bar and light fixtures must be stowed
properly fot traiering or transporting. See
Tower Lights - Stowage for Trailering on page
20.
Light Bar and Light Fixture Adjust-
ment (Vertical Tower)
Lights - Work Site Adjustment
The light bar and light fixtures must be adjusted
to the desired work angle before raising the
light tower.
With the light tower fully lowered and the lights
off, the light bar assembly and light fixtures can
be manually rotated into the desired working
position.
To adjust the light bar, release the light bar park
pin (figure 16, 1) by pulling the ring and turning
it 90 degrees so that the pin remains in the re-
tracted position.
With the light bar park pin released, the light bar
is designed to be manually rotated with enough
resistance so that the bar will stay in the de-
sired position once the operator has directed
the lights on the work zone.
If the light bar rotates too easily or does not
stay in position, remove the cap plug from the
center of the light bar cover and tighen the nut
to achieve the desired resistance and replace
the cap plug.
To adjust each light fixture, manually swivel
each light fixture at its base into the desired
working position (Figure 17).
PARK PIN
1
1 - grasp light fixture here to adjust
Figure 17