Allmand Brothers NL PRO II - Manual (Page 24)

24
TRAILERING, TRANSPORTING AND LIFTING
The trailer’s safety chains prevent the trailer
from completely detaching from the towing vehi-
cle when underway.
NOTICE: Safety chains must be rated at the
same or greater weight capacity as the trailer’s
GVWR.
Before trailering, read page 17.
1. Connect the tow vehicle hitch to the trailer
coupler. Make sure the coupler is securely
attached to the tow vehicle’s hitch.
2. Connect the safety chains ( Figure 27, 2) to
the vehicle’s hitch frame and crisscross the
chains under the trailer tongue to prevent
the tongue from dropping to the road if the
trailer separates from the hitch ball. Rig the
chains as tight as possible with enough
slack to permit free turning.
Warning! Control hazard. Attach the
safety chains properly and securely be-
tween the towing vehicle and trailer be-
fore trailering. Never allow the chains to
drag the ground when trailering.
3. Connect the 4-pin light connector (Figure
27, 1) from the vehicle harness to the trailer
harness.
4. Ensure there is adequate slack in the har-
ness to prevent from binding or disconnect-
ing when turning.
NOTICE: Do not allow excessive harness
slack or the harness can be damaged from
scraping the ground.
5. Before trailering, check all lights for proper
operation.