ARM Electronics DVRHD OSD - Manual (Page 29)

OSD Setup Manual
28
Camera Setup ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
The items in the Camera Setup menu enable users to set camera parameters, including
camera title, dome protocol and ID for each connected camera. There will be separate
menus for analog cameras and IP cameras. Please refer to <Analog Camera> section if the
connected camera is an analog camera, or refer to <IP Camera> section when the
connected camera is an IP camera.
< Analog Camera >
If the connected camera is an analog camera, please continue with this section. Items in
this menu are described in the following subsections.
Analog Camera
Analog Camera Select
Dome Protocol
Dome ID
Camera Title
Covert
Brightness
Contrast
Saturation
Hue CH1
None
0
CH1
No
0
0
0
0
„ Analog Camera Select
This item is used to select a camera for setting the parameters. The related
settings will follow the selected camera, such as dome protocol and camera title.
Move the cursor to <Analog Camera Select> and press ENTER, then select a
channel using UP / DOWN keys.
„ Dome Protocol
If the connected camera is a dome camera, select the communication protocol
associated with the dome camera using ENTER and Direction keys. The default is
set to <None>.
„ Dome ID
This item is used to assign an ID number to the selected dome camera. Note that
ID number must match the ID address set by the dome camera.
„ Camera Title
This item allows the users to change the title of each connected camera. By default,
the titles of cameras are numbered from 1 through 16 respectively. The title will be
displayed on the screen after the changes of the titles are set.