ARM Electronics DVRHD OSD - Manual (Page 51)

OSD Setup Manual
50
< Export Config >
Users are allowed to save a DVR configuration by exporting it to an external drive, such as
an USB Flash Drive. Before exporting the configuration, make sure the device in which the
configuration will be saved is attached to the DVR appropriately. Select <Export Config>
from the Configuration menu and press ENTER. The following menu is displayed.
Export Config
Copy Destination
Config Name
Begin Export
No
Items in this menu are described in the following sections.
„ Copy Destination
Enter this item to list available destinations (external storage devices) where the
configuration can be exported. Press UP/ DOWN to select a destination. Please
note that saving a different configuration to the same destination with the same file
name will overwrite the previous configuration file without warning.
Copy Destination
Device Name
xxxx-xxxx Select
No
NOTE: It is not allowed to select the built-in DVD+RW as a copy
destination.
„ Config Name
This item allows users to assign a name to the exported configuration file. Use the
virtual keyboard to enter the configuration file name. Note that the file name can
only contain up to 15 characters, with no spaces.
„ Begin Export
Select <Yes> to begin exporting the configuration file, or select <No> to exit.
NOTE: It is strongly recommended to export configuration before upgrading
the DVR system. Also, backup the configuration routinely is recommended
as well, just in case for unexpected situation.