ARM Electronics RT4CD - Manual (Page 25)

22
4.10 ADVANCE MENU ___REMOTE 4.10 ADVANCE MENU ___REMOTE
Move the cursor to “REMOTE” and press ”ENTER”. The screen will show the
following options.
REMOTE REMOTE
TITLE DEVICE ID PROTOCOL RATE
01 PTZ 001 P - D 02400
02 CAMERA 002 NORMAL 02400
03 CAMERA 003 NORMAL 02400
04 CAMERA 004 NORMAL 02400
1) TITLE:
Title of each camera.
2) DEVICE:
Select to control normal cameras or PTZ cameras for each channel.
3) ID:
Set the ID number (0 ~ 255) of PTZ camera.
Note: After connecting to PTZ correctly, the default ID of PTZ will be shown on the
screen
.
Note: Please refer to the below instruction “PTZ Connection and Control”
4) PROTOCOL:
Select NORMAL (our protocol) or PELCO-D protocol.
5) RATE:
Set the baud rate of each channel (2400, 4800, 9600, 19200, 57600). For the
connected cameras, such as PTZ and speed dome cameras, etc., please make
sure the baud rate setting is the same as the setting here.
***PTZ Connection and Control: *** ***PTZ Connection and Control: ***
• • Device Device: Our own brand PTZ / Pelco-D protocol PTZ
• • Connection Connection: For detailed connection and instructions, please refer to PTZ manuals.
Note: Note:
As for “RS485A and RS485B Port”, please refer to
“Section 1.5 Rear Panel”, or refer
to “Appendix #2 PIN Configuration”.
• • Control Mode Control Mode: Refer to the front panel description in “Section 1.4_FRONT PANEL”
at P.4 and 5.
For detailed PTZ operation, please refer to PTZ manuals.