ARM Electronics RT4CD - Manual (Page 53)

Carefully follow the steps to ensure correct installation.
*** Note: Please set the HDD to “Master Mode” or “Single Mode” ***
1) Open the upper cover of the DVR and screw out the bracket.
2) Screw HDD onto the HDD bracket. (Refer to Fig.1 & 2)
3) Connect the HDD to the power connector and IDE BUS (make sure to align
the HDD precisely for pin connection)
And then screw the HDD bracket onto the DVR base. (Refer to Fig. 3)
4) Close the upper cover of the DVR. (Refer to Fig. 4 & 5)
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5
50
Note: The images shown above may differ from the actual product appearances.
(Model 2, 3 & 4) (Model 2, 3 & 4)