ARM Electronics RT4CD - Manual (Page 27)

4.12 ADVANCE MENU ___NETWORK 4.12 ADVANCE MENU ___NETWORK
24
Move the cursor to “NETWORK” and press ”ENTER”. The screen will show the
following options.
NETWORK NETWORK
NETWORK TYPE STATIC
DNS 61. 66. 138. 53
PORT 0 0 8 0
1) NETWORK TYPE (STATIC):
Select NETWORK TYPE, press “＋” or “－” button to set the network type as
STATIC, and then press “ENTER” to go to the submenu of the network. In
the submenu of network type, use “＋” or “－” button to set all the information
needed in the DVR. See the illustration below.
2) NETWORK TYPE (DHCP):
The DHCP function needs to be supported by a router or a cable modem network
with DHCP services. For detailed DHCP settings, please follow the AP (Licensed
Software AP) setup, and then refer to P36 and P37.
3) NETWORK TYPE (PPPoE):
This PPPoE function needs to have one “username” and one “password”
subscribed from one ISP supplier.
For detailed PPPoE settings, please follow the AP (Licensed Software AP) setup,
and then refer to P36 and P37.
NOTE:
DHCP and PPPoE network types need to apply DDNS services to get “Hostname” to
correspond to the dynamic IP address. For detailed DDNS settings, please refer to
P.37.
STATIC STATIC
IP 60. 121. 46. 236
GATEWAY 60. 121. 46. 226
NETMASK 255. 255. 255. 254