ARM Electronics RT4CD - Manual (Page 36)

g. Record: press this button to start recording, and press this button again to stop
recording. The recorded files will be saved to the designated path on the PC.
Each recorded file can be up to 18,000 frames. When the recorded file is full, the
new recorded file will be saved as the second file.
If the HDD space is less than 200MB, the program will stop recording.
h. System Config: press this button to enter the setting page of the software AP.
i. Number of Online Users
j. CH 1 ~ 4
k. 4 Channel Display
l. Record
m. Search
n. Stop / Fast Rewind / Fast Forward / Pause / Slow Playback / Play
o. ＋ : for changing system settings and switching channels
p. － : for changing system settings and switching channels
q. Digital Zoom: digital zoom in/out
r. Set: Press this button to change the position of the channel display.
Press “
▲▼
◄► ” to select the channel that you would like to change.
Press “＋” or “－” to select the channel that you would like to show.
Press “Enter” button to confirm the setting.
s. Sequence: Press this button to enter the call monitor function and press again to
exit from the call monitor mode. When any motion is detected, the monitor will
switch to the channel which is motion-triggered.
t. Enter: for confirming the system settings or entering your selection.
u. PTZ Control On / Off:
When the PTZ control is turned on, users could select the PTZ device, and press
“OK” button to enter the PTZ control AP screen. (Press “ESC” to exit from the
PTZ control AP screen and return to the DVR control AP screen)
v. Menu / Up / Down / Left / Right
w. Turbo ON/ OFF:
To speed up menu selection or the control of the PTZ camera under software AP,
users could activate "Turbo" function by clicking this button. Users are allowed to
change the turbo steps from 1 to 10.
Ex: If users activate the TURBO function and set the value of the turbo step as 3,
then when users press one of the button up/down/left/right, one mouse click
will function as clicking 3 times.
33