Configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S12500-X Series Switches User Manual

Page 169

Advertising
background image

158

Configuration example

Network requirements

As shown in

Figure 60

, configure an IPv6 over IPv6 tunnel between Switch A and Switch B so the two IP

networks can reach each other without disclosing their IPv6 addresses.

Figure 60 Network diagram

Configuration procedure

Make sure Switch A and Switch B have the corresponding VLAN interfaces created and can reach each

other through IPv6.

Configure Switch A:
# Specify an IPv6 address for VLAN-interface 100.

<SwitchA> system-view

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ipv6 address 2002:1::1 64

[SwitchA-Vlan-interface100] quit

# Specify an IPv6 address for VLAN-interface 101, which is the physical interface of the tunnel.

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] ipv6 address 2001::11:1 64

[SwitchA-Vlan-interface101] quit

# Create service loopback group 1 and specify its service type as tunnel.

[SwitchA] service-loopback group 1 type tunnel

# Assign Ten-GigabitEthernet 1/0/3 to service loopback group 1.

[SwitchA] interface Ten-GigabitEthernet 1/0/3

[SwitchA-Ten-GigabitEthernet1/0/3] port service-loopback group 1

[SwitchA-Ten-GigabitEthernet1/0/3] quit

# Create an IPv6 tunnel interface tunnel 1.

[SwitchA] interface tunnel 1

# Specify an IPv6 address for the tunnel interface.

[SwitchA-Tunnel1] ipv6 address 3001::1:1 64

# Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface.

[SwitchA-Tunnel1] source 2001::11:1

# Specify the IP address of VLAN-interface 101 on Switch B as the destination address for the
tunnel interface.

[SwitchA-Tunnel1] destination 2002::22:1

[SwitchA-Tunnel1] quit

# Configure a static route destined for the IPv6 network group 2 through the tunnel interface.

Vlan-int101
2001::11:1/64

Vlan-int100
2002:3::1/64

Vlan-int100

2002:1::1/64

Vlan-int101

2002::22:1/64

Switch A

IPv6 network

IPv6

group 1

Tunnel1
3001::1:1/64

Tunnel2

3001::1:2/64

IPv6

group 2

Switch B

IPv6 over IPv6 tunnel

Service loopback port

XGE1/0/3

XGE1/0/3

Advertising
This manual is related to the following products: