Verifying the configuration – H3C Technologies H3C S12500-X Series Switches User Manual

Page 179

Advertising
background image

168

[SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0

# Configure the source address of tunnel interface as the IP address of VLAN-interface 101 on

Switch A.

[SwitchA-Tunnel1] source vlan-interface 101

# Configure the destination address of the tunnel interface as the IP address of VLAN-interface 101
on Switch B.

[SwitchA-Tunnel1] destination 2.2.2.2

[SwitchA-Tunnel1] quit

# Configure a static route from Switch A through the tunnel interface to Group 2.

[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1

2.

Configure Switch B:
# Create service loopback group 1, and configure the service type as tunnel.

<SwitchB> system-view

[SwitchB] service-loopback group 1 type tunnel

# Add port Ten-GigabitEthernet 1/03 to service loopback group 1.

[SwitchB] interface Ten-GigabitEthernet 1/0/3

[SwitchB-Ten-GigabitEthernet1/0/3] port service-loopback group 1

[SwitchB-Ten-GigabitEthernet1/0/3] quit

# Create a tunnel interface Tunnel 1, and specify the tunnel mode as GRE over IPv4.

[SwitchB] interface tunnel 1 mode gre

# Configure an IP address for the tunnel interface.

[SwitchB-Tunnel1] ip address 10.1.2.2 255.255.255.0

# Configure the source address of tunnel interface as the IP address of VLAN-interface 101 on

Switch B.

[SwitchB-Tunnel1] source vlan-interface 101

# Configure the destination address of the tunnel interface as the IP address of VLAN-interface 101
on Switch A.

[SwitchB-Tunnel1] destination 1.1.1.1

[SwitchB-Tunnel1] quit

# Configure a static route from Switch B through the tunnel interface to Group 1.

[SwitchB] ip route-static 10.1.1.0 255.255.255.0 Tunnel 1

Verifying the configuration

# Display tunnel interface information on Switch A.

[SwitchA] display interface tunnel 1

Tunnel1

Current state: UP

Line protocol state: UP

Description: Tunnel1 Interface

Bandwidth: 64kbps

Maximum Transmit Unit: 1476

Internet Address is 10.1.2.1/24 Primary

Tunnel source 1.1.1.1, destination 2.2.2.2

Tunnel keepalive disabled

Tunnel TTL 255

Tunnel protocol/transport GRE/IP

Advertising
This manual is related to the following products: