Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 205)

September 6, 2006 K2 Storage System Instruction Manual 205
Setting up the K2 media server
16.If you have a trunk, verify that for the default VLAN the trunk is displayed in the
Tagged Ports column.
17.If you have two switches, repeat this procedure for the other switch.
18.Close the switch configuration application.
Setting up the K2 media server
Do the following to prepare each K2 media server:
• Install the server in its permanent location. Refer to the rack mount instructions that
you received with the server’s product bundle.
• Provide power to the servers.
• Connect cables as follows:
Connect the two iSCSI interface ports to media ports on the GigE switch.
Connect A servers to the A GigE switch. Connect B servers to the B GigE
switch.
Connect the motherboard GigE port 1 and GigE port 2 to control ports on the
GigE switch. Connect A servers to the A GigE switch. Connect B servers to the
iSCSI interface
Power
Keyboard/Mouse
GigE
3
2
1 Fibre Channel
VGA monitor
GigE
(FTP) (control)
ports
(GigE media)
port 1
(USB)
Serial port
port 2