Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 50)

50 K2 Storage System Instruction Manual September 6, 2006
Chapter 2 Installing the Level 1 Storage System
NOTE: It is not necessary to use Storage Utility to bind LUNs, as this is already
done on systems shipping from the factory. If you are not working on a factory
prepared system, make sure LUNs are bound before attempting to create a file
system. Refer to the K2 Level 1 Instruction Manual.
Refer to “Prerequisites for initial configuration” on page 44 to confirm that the RAID
storage is ready for configuration.
1. In Storage Utility, click Tools | Make New File System . The Setting dialog box
opens.
2. For the Real Time Input/Output (RTIO) rate, enter the value specified by your
system design. If you do not know this value, contact your Grass Valley
representative.
3. If the K2 Storage System is to be accessed by only K2 Media Clients you can leave
Windows Security unchecked. If accessed by Aurora Edits, refer to the Aurora
Share Technical Reference Guide for instructions.
4. Click OK . The Configuration File dialog box opens.