Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 63)

September 6, 2006 K2 Storage System Instruction Manual 63
Setting up the Level 2 GigE switch
by default, so make sure you enable them. Leave Mode as default of Auto , and
set Flow Control to Disable .
d. Click Apply Settings .
6. On the Port Configuration page, do one of the following:
• If you do not have trunks, select all ports.
• If you have trunks, select the remaining ports (the ports not trunked).
7. Click Modify Selected Ports .
8. Make sure Port Enabled is set to Yes , leave Mode as default of Auto and set Flow
Control to Disable .
9. Click Apply Settings .
10.Choose VLAN Configuration . If prompted, log in with the switch’s administrator
username and password.