Grass Valley PDR 200 Service Manual - Manual (Page 128)

Chapter 6 Parts Removal and Replacement
6-36 PDR 200 Service Manual
To install the PCI board:
The three PCI board connectors (Figure 6-23) are keyed to ensure correct orientation
and the bottom of the board (which faces up when installed) identifies the connectors
as J1, J2, and J3. J2 is further identified as MASTER. Note that the SCSI cables to
the EDR boards must be connected prior to installation of the PCI board.
Figure 6-23. PCI Board
To install the PCI board, refer to Figures 6-22 and 6-23 and:
1. Hold the PCI with the connectors pointing down and the connector identifications
towards the rear of the Profile chassis (Figure 6-23).
2. Align the PCI connectors so that J1 is over the Fibre Channel board edge-board
contacts, Master J2 over the Master EDR connector, and J3 over the Slave EDR
connector, and the connector keys are over the key slots on the boards.
3. Attach the PCI board by gently but firmly pressing down until the PCI board is fully
seated on all three boards (Figure 6-22).
4. Reinstall the Profile chassis covers (page 6-8).
5. Perform the procedure to reinstall the Profile chassis in the rack (page 6-7).
6. Reconnect the power cord and turn PDR200 power On.
9674-15
Master
J1
J2
J3 Index Notch