Polaris 2014 BRUTUS Owner's Manual - Manual (Page 108)

106
MAINTENANCE
PTO Gearbox (If Applicable)
Removing And Replacing PTO Gearbox Fluid
Replace the PTO gear fluid at the correct service interval as outlined in the Periodic
Maintenance Chart beginning on page 73.
1. Stop the machine on a flat level surface. Put the gear selector in Park, stop the engine and
exit the vehicle. See page 40.
2. Install a container under the drain plug.
3. Remove the drain plug. Dispose of the used fluid
in an environmentally safe manner.
4. Reinstall the drain plug.
Torque: 11 ft-lbs (15 Nm)
5. The PTO gearbox requires special synthetic fluid.
Use only recommended fluid in the PTO gearcase.
6. Thoroughly clean the area around the breather tube
fitting and remove the fitting.
7. Install a piece of clear tubing on the end of the
gearcase fluid bottle. Add the proper amount of
fluid to the gearcase.
8. Reinstall the fitting and make sure the end of the
breather tube is positioned in the cross member
that is behind the operators seat.
WARNING! Always clean up spilled fuel or oil. Keep heat,
flames, sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause explosion
or fire.
Drain Plug
Fitting
Breather Tube
Clear Tube
Gearcase
Fluid Bottle