Maintenance, Fuel filter/water separator – Polaris 2014 BRUTUS Owner's Manual User Manual

Page 91

Advertising
background image

89

MAINTENANCE

Fuel Filter/Water Separator

The fuel filter/water separator is located under the

cargo box on the left side of the vehicle.
Inspect the separator daily for leaks. Drain water and

replace the separator at the intervals outlined in the

Periodic Maintenance Chart beginning on page 73.

Service the separator more frequently if the vehicle is

operated with poor quality fuel.

CAUTION! Both fuel and water will drain from the separator
during the following procedure. Use caution and observe all
fuel safety precautions when handling fuel.

1. Raise the cargo box.
2. Place an appropriate container under the fuel filter

drain to catch fluids (water and fuel).

3. Slightly loosen the bleed screw to relieve fuel pressure in the filter. Do not tighten the

screw at this time.

4. Reach under the fuel filter and slightly loosen the drain valve until the fluids drain from

the drain hole. Do not completely unscrew the drain valve.

5. When fluids stop draining from the valve, tighten

the valve firmly (by hand only).

6. Tighten the bleed screw.
7. With the gear selector in Park, turn the key to the

ON position. Do Not start the engine.

8. The fuel pump will start pumping fuel with the key

in the ON position (10 -15 seconds) and will force

air out of the fuel system.

9. At times it may be necessary to open the bleed

screw on the fuel filter housing until fuel comes

from the valve with no air bubbles.

10. Clean up any spilled fuel and soiled shop towels

properly.

11. Start the engine and check for fuel leaks.
12. Lower the cargo box.

Drain Valve

Bleed Screw

Drain Hole

(viewed from bottom)

Tighten

Loosen

Advertising
This manual is related to the following products: