Operation, Fuel recommendations, Additional technical fuel requirements – Polaris 2014 BRUTUS Owner's Manual User Manual

Page 36

Advertising
background image

34

OPERATION

Fuel Recommendations

NOTICE: For the best engine performance, to prevent engine damage and to comply with EPA/CARB

warranty requirements, use ONLY the recommended diesel fuels. Use only CLEAN diesel
fuel.

POLARIS recommends the following diesel fuels for use in this vehicle:
• Low Sulfur
• Ultra Low Sulfur #2
• #1 Diesel Fuel containing no more than 5% bio-diesel (see page 35)
See page 37 for cold weather fuel blend recommendations. For more information about

recommended diesel fuels and the consequences of using bio-diesel fuel exceeding 5% bio-

diesel, see Additional Technical Fuel Requirements below.
Diesel fuel should comply with the following world-wide specifications.

Additional Technical Fuel Requirements

• The fuel cetane number should be equal to 45 or higher.
• The sulfur content must not exceed 0.5% by volume. Less than 0.5% is preferred.

Especially in the U.S.A. and Canada, Low Sulfur (300 to 500 ppm (mg/kg) or Ultra Low

Sulfur fuel should be used.

• Bio-Diesel fuels: see pages 35-36.
• NEVER mix kerosene, used engine oil or residual fuels with diesel fuel.
• Water and sediment in the fuel should not exceed 0.05% by volume.
• Keep the fuel tank and fuel-handling equipment clean at all times.
• Poor quality fuel can reduce engine performance and/or cause engine damage.
• Fuel additives are not recommended. Some fuel additives may cause poor engine

performance.

• Ash content must not exceed 0.01% by volume.
• Carbon residue content must not exceed 0.35% by volume. Less than 0.1% is preferred.
• Total aromatics content should not exceed 35% by volume. Less than 30% is preferred.
• PAH (polycyclic aromatic hydrocarbons) content should be below 10% by volume.
• Metal content of Na, Mg, Si and Al should be equal to or lower than 1 mass ppm (test

analysis method JPI-5S-44-95).

• Lubricity: Wear mark of WS1.4 should be Max. 0.018 in. (460μm) at HFRR test.

Diesel Fuel Specification

Location

ASTM D975

No. 1D S15, S500

No. 2D S15, S500

USA

EN590:96

European Union

ISO 8217 DMX

International

BS 2869-A1 or A2

United Kingdom

JIS K2204 Grade No. 2

Japan

KSM-2610

Korea

GB252

China

Advertising
This manual is related to the following products: