Maintenance, Engine oil – Polaris 2014 BRUTUS Owner's Manual User Manual

Page 84

Advertising
background image

82

MAINTENANCE

Engine Oil

Always check the oil level daily. Change the engine oil at the intervals outlined in the

Periodic Maintenance Chart beginning on page 73. Always change the oil filter whenever

changing oil.

WARNING! Vehicle operation with insufficient, deteriorated or contaminated engine oil will cause
accelerated wear and may result in engine seizure, accident and injury. Always perform the
maintenance procedures as outlined in the Periodic Maintenance Chart.

Oil Recommendations

NOTICE: Use of a non-recommended engine oil may cause serious engine damage.

POLARIS recommends the use of POLARIS Diesel Oil (SAE CI-4) for this vehicle. Always

use the correct viscosity grade based on the ambient temperature expected during operation.

See the chart below.

Oil Viscosity/Ambient Air Temperature Chart

Oil Check

The oil dipstick is located on the engine under the

passenger seat.

Tip: Engine oil should be checked cold or allow time for the

oil to drain back into pan before checking to prevent
overfilling.

1. Position the vehicle on a level surface.
2. Stop the engine.
3. Tilt the rear cargo box to access the engine oil

dipstick.

4. Remove the dipstick. Wipe it dry with a clean

cloth.

5. Reinstall the dipstick, then remove it and check the

oil level. Maintain the oil level in the safe range.

Do not overfill.

Tip: Due to the dipstick entry angle into the crankcase, the oil

level will read higher on the bottom side of the dipstick.
Always read the level on the upper surface of the
dipstick.

-25° F

(-31° C)

+5° F

(-15° C)

+80° F

(+27° C)

+104° F

(+40° C)

SAE 15W-40

Synthetic 5W-40

SAE 10W-30

Safe

{

Safe

Range

Check Level

on Top Side

Dipstick

Add

Advertising
This manual is related to the following products: