Safety, Operator safety – Polaris 2014 BRUTUS Owner's Manual User Manual

Page 15

Advertising
background image

13

SAFETY

Operator Safety

• Always follow the proper procedures outlined in this manual for traveling downhill and

for braking on hills. See page 52. Check the terrain carefully before descending a hill.

Never travel downhill at high speed. Avoid going downhill at an angle, which would cause

the vehicle to lean sharply to one side. Travel straight down the hill where possible.

• Always check for obstacles before operating in a new area. Never attempt to operate over

large obstacles such as large rocks or fallen trees. Always follow the proper procedures

outlined in this manual when operating over obstacles. See page 53.

• Always be careful of skidding or sliding. On slippery surfaces such as ice, travel slowly

and exercise caution to reduce the chance of skidding or sliding out of control.

• Never operate your vehicle in fast-flowing water or in water deeper than that specified in

this manual. See page 54. Wet brakes may have reduced stopping ability. Test your brakes

after leaving water. If necessary, apply them lightly several times to let friction dry out the

pads.

• Always be sure there are no obstacles or people behind your vehicle when operating in

reverse. When it's safe to proceed in reverse, move slowly. Avoid turning at sharp angles

in reverse.

• Always use the proper size and type of tires specified in this manual. Always maintain

proper tire pressure as specified on safety labels.

• Never modify this vehicle through improper installation or use of non-POLARIS-

approved accessories.

• Never exceed the stated load capacity for this vehicle. Cargo should be properly

distributed and securely attached. Reduce speed and follow the instructions in this manual

for hauling cargo, with attachments installed or pulling a trailer. Allow a greater distance

for braking. Keep the attachment arm low (if equipped) and slow down when turning.

• Always place the transmission in PARK before getting out of the vehicle.
• Disengage PTO (if equipped), put the gear selector in PARK, stop the engine and make

sure all rotating components are stopped before exiting utility vehicle.

• Always stop the engine before refueling. Remove flammable material containers from the

box before filling them with fuel. Make sure the refueling area is well ventilated and free

of any source of flame or sparks. Fuel is extremely flammable. See page 36 for fuel safety

warnings.

• Always remove the ignition key when the vehicle is not in use to prevent unauthorized use

by someone under the age of 16 or without a driver’s license and proper training, or

accidental starting.

Advertising
This manual is related to the following products: