Yaskawa MP940 - Manual (Page 113)

MP940 Functions
4.2.8 General-purpose Serial Definitions
4-20
„ General-purpose Serial Parameter Default Values
The following table shows the default values for the general-purpose serial parameters.
Item CIR01 CIR02
Rack No. 01 01
Slot No. 02 02
Circuit No. 01 02
Transmission Protocol MEMOBUS MEMOBUS
Master/Slave Slave Slave
Device Address 01 02
Serial Interface RS-232C RS-485
Transmission Mode RTU RTU
Data Length 8 bits 8 bits
Parity Bits Even Even
Stop Bits 1 1
Baud Rate 9,600 bps 9,600 bps
Transmission Delay Not designated. Not designated.
Automatic Reception Not designated. Not designated.
Input Relay Read IW0000/2048 IW0000/2048
Input Register Read IW0000/2048 IW0000/2048
Coil Read/Write MW00000/32768 MW00000/32768
Holding Register Read/
Write MW00000/32768 MW00000/32768
Coil/Holding Register
Write Range MW00000/32767 MW00000/32767