Edirol PC-80 - Manual (Page 60)

60
Using the PC-80 as a MIDI controller keyboard
■
What is PLAY mode?
This is the mode in which you play the PC-80.
When you play the keyboard, note messages will be transmitted, causing a connected MIDI
device to produce sound.
In addition to playing the keyboard to produce sound on a connected sound module, Play
mode also lets you use the pitch bend/modulation lever to change the pitch of the sound (Pitch
Bend) or apply vibrato (Modulation), and also to switch octaves (Octave Shift).
In addition, you can change the MIDI transmit channel, send program change messages,
transmit specific parameters, or transmit start/stop messages.
■
To enter Play mode
The PC-80 will automatically be in Play mode when you turn on its power.
To switch from Utility mode (p. 61) to Play mode, simultaneously hold down the MIDI CH
button and PGM CHANGE button for a few moments, or press the CANCEL button.
fig.util
• You’re returned to Play mode after you complete a setting or operation in
Utility mod
• You are also returned to Play mode if you cancel an operation in Utility mode.
In this case, the setting you were in the process of making will be cancelled.
fig.util
To switch from Soft Synth mode (p. 33) to Play mode, press the SOFTWARE
SYNTHESIZER button to turn it off.
■
Functions in PLAY mode
The PC-80’s basic operating modes
Play mode
Perform
Use the keyboard, pitch bend/modulation lever, HOLD pedal, and EXPRESSION
pedal to transmit MIDI messages.
p. 32
Specify the MIDI
transmit channel
Use the VALUE encoder to specify the transmit channel for the
keyboard, pitch bend/modulation lever, HOLD pedal, and
EXPRESSION pedal.
p. 62
Specify the keyboard
mode Set the keyboard mode to Lower mode, Upper mode, or Split mode. p. 35,
p. 37
Transmit a program
change message
Use the VALUE encoder to transmit a program change message.
* For details on transmitting a bank select message refer to p. 65 and pp.
66.
p. 64
Start playback
(START)
In Controller mode (p. 67) you can press the MIDI
CH button to transmit a Start (FAh) message.
p. 68
Stop playback
(STOP)
In Controller mode (p. 67) you can press the PGM
CHANGE button to transmit a Stop (FCh) message.
p. 69
Transmit a specific
parameter value
In Controller mode (p. 67) you can operate the
VALUE encoder to transmit a specific parameter
value.
p. 78
PLAY
PC-80_e.book 60 ページ ２００５年１１月１０日 木曜日 午前１１時３４分