Edirol PC-80 - Manual (Page 62)

62
Using the PC-80 as a MIDI controller keyboard
Each of the PC-80’s modes uses the transmit channel listed in the following table.
In order to control a sound module, you must set the PC-80’s current channel to match the
MIDI receive channel of your sound module.
fig.MIDIch-1_76
Make sure that the PC-80’s SOFTWARE SYNTHESIZER button is not lit.
If you’re in Controller mode (p. 67), switch to Play mode.
fig.MIDIch
1
Press the MIDI CH button.
The MIDI CH button will light. The display will indicate the current channel.
2
Use the VALUE encoder to specify the channel number you want to use.
The current channel has now been set.
Transmitting various MIDI messages from the PC-80
Mode Channel
UPPER UPPER
LOWER LOWER
SPLIT UPPER
Setting the MIDI transmit channel
Range 1–16
PLAY
Current channel
The “current channel” is the MIDI transmit channel for the keyboard, pitch bend/modulation
lever, VALUE encoder, hold pedal, and expression pedal.
1 2
PC-80_e.book 62 ページ ２００５年１１月１０日 木曜日 午前１１時３４分