MCZ Comfort Air SLIM - Manual (Page 23)

SLIM-BASIC COMFORT AIR KIT Chapter 3
USE AND MAINTENANCE MANUAL page
23
Basic comfort air kit Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
 Push the flap inwards at the bottom right corner of the
motor support with force to allow the same to be released
from the pin.
 Lift the flap by 90° and push it in until it is released.
 Now, remove the four M3 screws (two to the left and two
to the right) which hold the internal flap necessary to
secure the control unit in place
 Remove the flap from the motor support and break the
pre-perforated panel (hit it with a hammer and remove it)
M3
SCREWS
FLAP
ATTACHMENT
PIN