MCZ Comfort Air SLIM User Manual
Page 26
SLIM-BASIC COMFORT AIR KIT
Chapter 3
USE AND MAINTENANCE MANUAL
page
26
Basic comfort air kit
Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
2.4. REMOTE CONTROL
2.4.1.
Light operation (keys 1-3)
Turn the lights on by holding down key “1” on the remote control;
prolonged pressure increases the intensity of brightness, while pressing
key “3” decreases brightness until the lights go out completely.
The lesser the brightness the lower the electricity consumption.
2.4.2.
Fan operation (keys 2-4)
Turn the fans on by holding down key “2” on the remote control;
prolonged pressure increases the speed, shown by the number of LEDs
illuminated on the board. There are 4 different speeds, corresponding
to 4 different air flows.
Press key “4” to decrease the speed until the fans are turned off
completely.
If the temperature sensor (optional) is not connected to the control
unit, the operation of the fans is independent from the temperature of
the air in the closed fireplace.
2.5. KIT OPERATING MODES
2.5.1.
Manual operation
With the temperature sensor not connected, the fans are operated
directly from the remote control.
2.5.2.
Automatic operation with temperature
sensor
When the temperature sensor is connected, press ON/OFF key
(2) and, if the closed fireplace is still cold, the 4 LEDs start to
flash. The fan starts to rotate at low speed to encourage the
flow of air towards the sensor;
With the closed fireplace warm, when 50°C are reached (the
LEDs stay on), the motor is operated at the value requested by
the customer; to avoid any inadvertent ON/OFF operations, the
reading of the sensor is inhibited during the first 5 minutes of
operation
Shut-down: below 42°C (from 41° to 39.5°C), the motor is
operated at minimum speed again and the LEDs begin to flash
again. This makes it possible to make the most of all the
residual heat from the closed fireplace, as well as immediate
restarting when the flame is revived
Below 39.5°C, the motor and control unit are turned off; the
control unit will have to be turned back on for restarting.
FAN SPEED LEDS