RIGOL DP832A - Manual (Page 71)

Chapter 2 Front Panel Operations RIGOL
DP800A User’s Guide 2-17
To Set the Timer Parameters
Press Timer  Timer Set to enter the timer parameter setting interface as shown
in the figure below. The channel currently selected is displayed in the status bar.
Press the channel selection keys at the front panel to switch the channel currently
selected. This interface provides timer parameter preview; users can view the values
on the current page of the timer parameter list (the horizontal axis represents time
and the vertical axis represents voltage and current).
Figure 2-2 Timer Parameter Setting Interface
You can set the timer parameters in the timer parameter setting interface following
the steps below.
1. To Set the Number of Output Groups
2. To Set the Number of Cycles
3. To Set the End State
4. To Edit the Timer Parameters
5. To Save and Read the Timer File
Tip
The timer function and delayer function are mutually exclusive. When the timer is
enabled, Delayer is grayed out and disabled; when the delayer is enabled, Timer
is grayed out and disabled.
Timer Parameter Preview Channel Currently Selected Timer Parameter List