TA Triumph-Adler P-C3570DN - Manual (Page 140)

Using the Operation Panel 4-67
The IP addresses currently used on the Internet (IPv4) have a fixed length
of 32 bits.
1
In the IPv4 Setting menu, press  or  to select IP Address.
2
Press [OK]. The IP Address screen appears.
3
Use the arrow keys to set the IP address.
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. You can set any value between 000 and 255.
Use  and  to move the cursor right and left.
4
Press [OK]. The IP address is stored and the IPv4 Setting menu
reappears.
Subnet Mask (Subnet mask setting)
The subnet mask is a way of augmenting the network address section of
an IP address.
A subnet mask represents all network address sections as 1 and all host
address sections as 0. The number of bits in the prefix indicates the
length of the network address. The term "prefix" refers to something
added to the beginning and, in this context, indicates the first section of
the IP address.
When an IP address is written, the length of the network address can
indicated by the prefix length after a forward slash (/). For example, "24"
in the address "133.210.2.0/24". In this way, "133.210.2.0/24" denotes
the IP address "133.210.2.0" with a 24-bit prefix (network section).
This new network address section (originally part of the host address)
made possible by the subnet mask is referred to as the subnet address.
1
In the IPv4 Setting menu, press  or  to select Subnet Mask.
2
Press [OK]. The Subnet Mask screen appears.
3
Use the arrow keys to set the subnet mask.
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. You can set any value between 000 and 255.
Note When you enter the IP address, be sure to set the DHCP
setting to Off.
Note When you enter the subnet mask, be sure to set the DHCP
setting to Off.
IP Address: a b
/123.145.167.123-
M
Subnet Mask: a b
/123.145.167.123-
M