Subaru Robin RGV12100 - Manual (Page 30)

27
8. CHECKING FUNCTIONAL MEMBERS
PILOT LAMP
8-2 AC RECEPTACLES
Using a circuit tester, check continuity
between the two terminals at the rear of the
AC receptacles while the receptacle is
mounted on the control panel. When continu-
ity is found between the output terminals of
the receptacle with a wire connected across
these terminals, the AC receptacle is normal.
When the wire is removed and no continuity
is found between these terminals, the recep-
tacles are also normal.
8-1 PILOT LAMP and VOLTMETER
Check the pilot lamp and the voltmeter if it is
turned on by applying specific voltage.
Pilot lamp and voltmeter cannot be checked
with circuit tester because its resistance is
too large.