PLANET IPX-1980 - Manual (Page 15)

2.3 Remote Management
The function can enable users to manage the Internet Telephony PBX system at remote sites
and to allow technical person to assist you in solving network problem.
Step 1. Go to Network & Country → HTTP port and Remote Administration.
Figure 2-5. HTTP port and Remote Administration
Step 2. Mark Remote Administration to active it. And then enter the control port you want to
use. The default value is 80.
Step 3. Click Apply to save the configuration. And you can type the http://WAN IP address:
to access the IPX-1980 from the remote side.
Step 4. To verify the IP address of your computer and the Internet Telephony PBX system.
Click Start form Windows → Run. Type the cmd to open the command window, then
type ipconfig for getting default gateway address. In the below case, the default
gateway is 192.168.0.1 and the user’s PC is 192.168.0.100.
Figure 2-6. Check the IP address for the PC and IPX-1980
15