Audio menu – Sony X85K 50" 4K HDR Smart LED TV User Manual
Page 48
48
Detailed Menu Description
C
h
a
p
te
r 5
M
e
nu
It
em
s
AUDIO Menu
The AUDIO menu allows you to adjust audio signals.
[F6]
SDI
Sets the format of SDI signals.
HDSDI
3GSDI
I/O
[F7]
DEPTH
Sets the bit length of input/output signals.
10bit
(fixed)
I/O
[F8]
COMPRS
Sets the compression mode.
SR-SQ
SR-Lite
In
[F9]
SET
Applies
the
settings.
I/O
[F10]
EXIT
Redisplays the previous menu.
–
Button
Indication
Setting
Target
Button
Indication
Setting
Target
[F1]
AUD
IN
(ch1 to 16)
Selects the input signal for each audio channel.
SDI:
Selects the signal input to the HD SDI INPUT A connector.
A/E:
Selects the signal input to the DIGITAL AUDIO INPUT (AES/EBU) connector.
In
[F2]
METER
Switches the display range of the audio level meters between FULL and FINE.
Full:
The audio level meter display is from –60 dB to 0 dB, or –40 dB to +20 dB. Use
the ALT/
[F10]
–
[F1]
(SCALE) menu item to set which range (peak level: 0 dB or
+20 dB) to display.
Fine:
The audio level meter display range is expanded, and the signal level is
indicated by a scale with 0.25 dB steps.
I/O
[F7]
SHTL AUD
Sets whether to disable the audio signal output during shuttle playback.
PB:
Turns muting off.
Muting:
Turns muting on.
Out
[F9]
MON MIX
Sets the method for mixing the digital audio output via the AUDIO MONITOR
OUTPUT L/R connectors.
add:
Simple addition
rms:
Geometric mean
ave:
Simple average
Out
[F10]
INT SG
Selects the operation of the internal audio test signal generator.
off:
Turns off operation of the audio test signal generator.
silence:
Silence signal
1 kHz:
1 kHz sine wave (In this case, a 1 kHz, –20 dB sine wave is supplied to all
audio inputs.)
In
ALT/
[F2]
NON-AUD
Selects a non-audio input signal. The setting is in units of stereo pairs.
When this is set to other than “off,” the setting of AUDIO INPUT select is disabled.
A/E:
Selects the signal input to the DIGITAL I/O (AES/EBU) INPUT connector as a
data input.
HD SDI:
Selects the signal input to the HD SDI INPUT A connector as a data input.
off:
Treats input as audio. Select the input signal in AUD IN select.
In
ALT/
[F3]
OUT PH
Sets the output timing for the digital audio playback signal (SDI and AES/EBU only).
The 64 setting specifies the reference position.
A setting lower than 128 advances the output timing, and a setting higher than 128
delays the output timing.
(128 samples = approx. 2.7 ms, 1 sample = approx. 20 µs)
0 to 128 to 255 samples
In
ALT/
[F4]
CH EXCHG
Sets the relation between the digital signals (audio multiplexed with HD SDI output
and AES/EBU-format audio output) assigned to channels 1 to 16, and playback
track.
ch1 to ch16
Out