Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 27)

How to operate the CD/MP3/WMA player
27
IV
Listening to CD
The front panel opens.
If a disc has already been loaded, the
disc will be ejected.
The front panel automatically closes
and the CD will immediately start
playing.
ATTENTION
• Playback may be intermittent when there is
a scratch on a CD or when the recorded
side is dirty.
• If a CD has already been loaded, press the
[SOURCE/PWR] button for less than one
second to switch to the CD mode. (For
details, refer to "Switching Audio Modes" on
page 18.)
NOTE
• When music data recorded in the normal
way (CD-DA) is present on the same disc
with MP3/WMA music files, the normally
recorded music data will be played. To
listen to the MP3/WMA music files, press
[MODE] button for more than one second.
• MP3/WMA files which are not supported
cannot be played. In this case, [NO
SUPPORT] is displayed.
• The optional CD changer cannot be used to
play MP3/WMA files.
TRACK (FILE) UP/DOWN
CD, MP3/WMA
(Right):
Advances to the next track.
(Left):
Returns to the beginning of the
track being played.
CD (Rotary mode)
(Right):
Advances to the next track.
(Left):
Returns to the beginning of the
track being played.
MP3/WMA (Rotary mode)
(Right):
Advances to the next track.
(Left):
Previews previous tracks.
1
Press the [ e (OPEN/EJECT)]
button.
2
Insert a CD into the disc slot, label
side up.
CAUTION 1 2
Do not press the [ e (OPEN/EJECT)]
button while a CD is being loaded. This
could cause injuries or damage to the front
panel.
1
Briefly press the [SELECT] (Right/
Left) button.
1 Turn the [VOL] button.
1
Press the [MODE] button for less
than one second to display the file
list.
2
Turn the [VOL] button to select the
file.
3 Press the [ENTER] button.