Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 39)

The Bluetooth audio function
39
VI
The portable device is set as a
Bluetooth audio source.
ATTENTION
• The Bluetooth audio (BT-Audio) function
can only be selected in the audio mode
when the BT Audio Set selection mode is
set to ON.
• The default setting for the Bluetooth audio
mode is OFF (BT-Audio selection is
disabled).
Connecting the main unit and the
portable device
The "Waiting" message appears on
the display.
ATTENTION
Press the [RTN/BAND] button to change the
portable device to be connected. The BT-
Audio Set selection mode is activated again.
The default setting value of the
passcode is 1234.
ATTENTION
• For details on how to operate the portable
device, read its instruction manual.
• Be sure to perform the connection of the
portable device only while the "Waiting"
message is on the display.
The portable device is now connected
to the main unit.
( and appear on the display.)
If the connection has not been
successfully completed, the "FAILED"
message appears on the display.
ATTENTION
• If the portable device is still connected,
disconnect it.
• If the connection has not been successfully
completed, and the "FAILED" message
appears on the display, connect the
portable device again, following the
procedure from the BT Audio Set selection
mode in Step 1.
• The passcode is a password used when
connecting the portable device to the main
unit.
• When the audio of the cell phone is
connected, hands-free can be connected at
the same time for some devices. If you want
to be able to use the hands-free function,
perform the hands-free connection
procedure again.
Disconnecting the main unit and the
portable device
The "Disconnect ?" message appears
on the display.
4
Press the [RTN/BAND] button.
1
Press the [SELECT] (Up/Down)
button while in the BT-Audio Set
selection mode to select Connect.
2
Press the [ENTER] button.
3
Input the passcode using the
portable device.
4
When the connection has been
completed, the "COMPLETED"
message appears on the display.
1
Press the [SELECT] (Up/Down)
button while in the BT Audio Set
selection mode to select
Disconnect.
2
Press the [ENTER] button.
3
Press the [ENTER] button.