Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 77)

How to operate the Sound Adjustment Mode
77
XII
Non-Fader Output settings (Output)
Right:
Monaural
Left:
Stereo
Speaker layout settings (SP
Layout)
Depending upon speaker layout, you can switch
between 3-way and 4-speaker systems. (Select a
system configuration before adjusting PEQ, time
alignment or cross over.)
The speaker layout setting mode is
activated.
"OK?" will be displayed.
Importing Sound Data (Sound
Data)
Sound data adjusted by the E-iSERV website
can be downloaded to a CD-R or a USB memory
and imported into the main unit.
The sound data importing mode is
activated.
• When selecting a CD-R:
The front panel will open automatically.
"INSERT DISC" will be displayed.
• When selecting a USB:
"CONNECT USB" will be displayed.
The files are automatically read.
The selected file is written on the
selected button.
The CD-R will be ejected automatically
when writing is complete.
The display will return to the file
selection screen.
1
Press the [SELECT] (Down) button
to select Output.
2
Press the [SELECT] (Right/Left)
button to select Monaural or
Stereo.
1
Press the [SELECT] (Up/Down)
button to select SP Layout.
2 Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select 3 WAY or 4 SP+SW.
4
Press the [ENTER] button for more
than five seconds.
5
Press the [ENTER] button for less
than one second.
CAUTION 1 2
When switching between 3 WAY and 4
SP+SW modes, please make sure that the
volume level is set to 0.
1
Press the [SELECT] (Up/Down)
button to select Sound Data.
2 Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select the media type
(Disc or USB).
4 Press the [ENTER] button.
5
Insert the CD-R or connect the USB
memory.
6
Press the [SELECT] (Up/Down)
button to select a file.
7 Press the [ENTER] button.
8
Select a button from [1] to [5], and
press it for more than two
seconds.