Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 76)

76
Various Settings
The slope can be set to “Pass”, “6dB/
oct”, “12dB/oct”, “18dB/oct” or “24dB/
oct”.
Up:
The slope becomes more gentle.
Down:
The slope becomes steeper.
Multi-harmonizer settings
(Harmonizer)
This function uses harmonic synthesis to restore
the high-frequency component that is lost as a
result of the compression process, so that
fresher sound can be obtained during MP3/
WMA, USB memory playback.
The harmonizer setting mode is
activated.
When the button is pressed, the
setting item changes in the following
order.
www ↔ Low ↔ Hi ↔ OFF↔ www
Hi:High effectiveness
Low:Low effectiveness
The selected settings will take effect.
Non-fader settings (Non-F
Setting)
• Non-fader phase (Phase)
The merging of sound between the front and
rear speakers and the woofer can be
improved by selecting the phase. Switch the
phase to a phase which lets the speakers
combine without any disharmony.
• Non-Fader Output (Output)
Non-Fader Output can be stereo or mono.
Select the method that matches the output
method for the sub-woofer system that is
connected to the main unit.
The non-fader setting mode is
activated.
Non-fader phase settings (Phase)
Right:
Reverse
Left:
Normal
5
Press the [SELECT] (Up/Down)
button to set the slope.
6
Repeat the steps 3 to 5 to change
the settings for each channel.
1
Press the [SELECT] (Up/Down)
button to select Harmonizer.
2 Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select a setting item.
1
Press the [SELECT] (Up/Down)
button to select NF Setting.
2 Press the [ENTER] button.
1
Press the [SELECT] (Up) button to
select Phase.
2
Press the [SELECT] (Right/Left)
button to select Reverse or
Normal.