Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 64)

64
Various Settings
How to operate the AUDIO CONTROL
Various Settings
Switching audio control modes
Various audio control modes may be fine-tuned using this procedure. Refer to Speaker Layout Settings
for more information.
Modes will switch in the order shown below each time the button is pressed.
3-Way Speaker Layout:
BASS → MID → TREB → LOUDNESS → SVC *1 → VOL→ BASS www
4 Speaker + Sub-Woofer Layout:
BALANCE
*2 → FADER *2 → NON-F *3 → LOUDNESS *2 → SVC *1 → VOL→ BALANCE *2
www
*1: Setting cannot be made in FM mode.
*2: Cannot be set when the CSII is set to ON.
*3: NON-F (non-fader) Output is not affected by the settings of the BASS, MID and
TREB.
1
Press the [ENTER] button for less than one second to select the item to be
adjusted.
Mode Function
Rotary Mode
Left Right
BASS Adjusts bass level. Decrease level. Increase level.
MID
(MIDDLE)
Adjusts middle level. Decrease level. Increase level.
TREB
(TREBLE)
Adjusts treble level. Decrease level. Increase level.
SVC
(Source Volume
Control)
Adjusts different volume levels for each audio
mode.
Decrease level. Increase level.
FADER
Adjusts the audio balance of the front and rear
speakers Emphasizes rear
speakers. Emphasizes front
speakers.
BALANCE
Adjusts the audio balance of the right and left
speakers Emphasizes the left
speakers. Emphasizes the
right speakers.
NON-F
(NON-FADER
LEVEL)
Adjusts non-fader level (for subwoofer).
Decrease the sub-
woofer level. Increase the sub-
woofer level.
LOUDNESS
The loudness control may be turned on to
emphasize low and high frequencies at low
volume levels.
Loudness boosts bass and treble at low volumes.
Select OFF Select ON