Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 56)

56
Operation
ATTENTION
• If there is no space remaining in the main
unit for phonebook data, the "MEMORY
FULL" message appears on the display
when an attempt is made to transfer data
from the cell phone.
• Some cell phones cannot transfer all of the
phonebook data at once. In this case,
transfer one data at a time.
• If the battery terminal of the vehicle is
disconnected, the phonebook data
registered in the main unit will be deleted.
Setting Auto Answer
When there is an incoming call, the phone can be
set to answer it automatically five seconds after
the phone starts ringing.
ON:
Auto Answer is activated
OFF:
Auto Answer is disabled
ATTENTION
The default setting for Auto Answer is OFF
(Auto Answer is disabled).
Setting the ring tone
The ring tone can be set on or off for incoming
calls. Ring tone is set ON by default.
Setting Auto Answer for registered
cell phones
Cell phones which have been registered to the
main unit will be connected automatically, if the
main unit and the Bluetooth are in an area where
connection is possible.
Auto answer is set ON by default and may not be
available for all cell phones.
ON :
Connects automatically.
OFF :
Must be connected manually.
1
Press the [SELECT] (Up/Down)
button while in the Phone Setting
selection mode to select Auto
Answer.
2
Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select ON or OFF.
0WODGTQHRJQPGPWODGTUVJCVECP
DGTGIKUVGTGFKPVJGRJQPGDQQM
1
Press the [SELECT] (Up/Down)
button while in the Phone Setting
selection mode to select Ring
Tone.
2
Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select ON or OFF.
1
Press the [SELECT] (Up/Down)
button while in the Phone Setting
selection mode to select Auto
Connect.
2
Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select ON or OFF.