Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 35)

How to operate the USB music file player
35
V
Listening to music files in USB
memory
For details, refer to "Switching Audio
Modes" on page 18.
The procedure for playing music is the
same as that are used to play CDs.
For details, refer to "How to operate
the CD/MP3/WMA player" (page 27 -
29).
ATTENTION
If the USB mode is changed to another mode
and then returned to the USB mode, the player
will return to the previous file played.
Disconnecting USB memory
ATTENTION
Do not remove the USB memory while playing,
reading or writing data.
1
Connect the USB memory to the
USB connector.
2 Switch to the USB mode.
3 Operate the USB music file player.
CAUTION 1 2
• Do not disconnect the USB memory or turn
the ignition key to ACC OFF position while
accessing the USB memory. Doing so may
corrupt the data.
• Depending on the type connected, the USB
memory may not work in some cases.
• The USB memory does not support multi-
partition. Also, it does not support USB hub.
• It is highly recommended to back up your
data in case of accidental deletion.
• Install and use the USB device in a place
that provides safe operation of the vehicle.
• The music files under the copyright
protection cannot be played.
• When connecting a digital audio player to
the USB connector, additional USB
adaptors may be required.
1
Disconnect the USB memory
parallel to the USB connector.
CAUTION 1 2
Do not apply excessive force when removing
the USB memory. Doing so may damage the
USB connector and/or the USB memory.