Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 53)

The Bluetooth hands-free function
53
IX
Registering a cell phone
Cell phones can be registered in the main unit.
There are two methods that can be used to
register a cell phone in the main unit.
The cell phone itself can be used or search for
cell phones using the main unit. A maximum of
five cell phones can be registered in the main
unit. Priority of connection will always be in
sequential order from 1 to 5. As cell phones are
added and deleted, the order will always go by
the numbered sequence.
Registering using a cell phone
If a cell phone is currently connected, it must be
disconnected prior to registration of additional
cell phones.
ATTENTION
NO ENTRY will be displayed if available. If not,
a double beep will be heard if the phone
registration memory is not available or full.
The "Waiting" message appears on
the display.
The default passcode is 1234.
ATTENTION
• For details on how to operate the cell
phone, read its instruction manual.
• Be sure to perform the registration of the
cell phone only while the "Waiting" message
is on the display.
The cell phone is now registered to the
main unit
( and
appear on the display.)
If the registration has not been
successfully completed, the "FAILED"
message appears on the display.
Repeat the registration procedure.
ATTENTION
• To register another cell phone to the main
unit, press the [RTN/BAND] button twice
after Step 6. Perform the registration
procedure from the registered cell phone
selection mode in Step 1.
• You cannot register a cell phone that has
already been registered.
• The hands-free function and the audio
function of the cell phone can be connected
at the same time for some cell phones.
Searching for cell phones to be
registered
ATTENTION
NO ENTRY will be displayed if available. If not,
a double beep will be heard if the phone
registration memory is not available or full.
1
Press the [SELECT] (Up/Down) to
select Registration within the
Phone Setting mode.
2
Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select Allow Connect.
4
Press the [ENTER] button.
5
Use the cell phone to input the
passcode.
6
When the registration has been
completed, the "COMPLETED"
message appears on the display.
1
Press the [SELECT] (Up/Down) to
select Registration within the
Phone Setting mode.
2
Press the [ENTER] button.