DJI Mavic 3 Pro Drone with Fly More Combo & RC - Manual (Page 106)

DJI Mavic 3 Pro User Manual
106
© 2023 DJI All Rights Reserved.
Firmware Update
Use DJI Fly or DJI Assistant 2 (Consumer Drones Series) to update the aircraft firmware.
Using DJI Fly
When connecting the aircraft or remote controller to DJI Fly, you will be notified if a new
firmware update is available. To start updating, connect your remote controller or mobile device
to the internet and follow the on-screen instructions. Note that you cannot update the firmware
if the remote controller is not linked to the aircraft. An internet connection is required.
Using DJI Assistant 2 (Consumer Drones Series)
Update the aircraft and remote controller firmware separately using DJI Assistant 2 (Consumer
Drones Series).
Follow the instructions below to update the aircraft firmware:
1. Launch DJI Assistant 2 (Consumer Drones Series) and log in with your DJI account.
2. Power on the aircraft and connect the aircraft to the computer via the USB-C port within 20
seconds.
3. Select DJI Mavic 3 Pro and click Firmware Updates.
4. Select the firmware version.
5. Wait for the firmware to download. The firmware update will start automatically.
6. The aircraft will reboot automatically after the firmware update is complete.
Follow the instructions below to update the remote controller firmware:
1. Launch DJI Assistant 2 (Consumer Drones Series) and log in with your DJI account.
2. Power on the remote controller and connect it to the computer via the USB-C port.
3. Select DJI Mavic 3 Pro Remote Controller and click Firmware Updates.
4. Select the firmware version.
5. Wait for the firmware to download. The firmware update will start automatically.
6. Wait for the firmware update to be completed.
• The battery firmware is included in the aircraft firmware. Be sure to update all batteries.
• Make sure follow all the steps to update firmware. Otherwise, the update may fail.
• Make sure the computer is connected to the internet during the update.
• Before performing an update, make sure the Intelligent Flight Battery is at least 40%
charged and the remote controller is at least 30% charged.
• DO NOT unplug the USB-C cable during an update.
• The firmware update will take approximately ten minutes. It is normal that the gimbal
goes limp, aircraft status indicators blink, and the aircraft reboots. Wait patiently until
the update is complete.
Refer to the Mavic 3 Pro Release Notes for more firmware update information for Traceability.